A Few Tips to Remove the Auto Stamping Parts Glitch

In the process of metal stamping parts processing, sometimes the stamping parts have some burrs of different sizes, which have a certain impact on product quality. So how should it be solved? Auto Stamping Parts Exporter to tell you:

One: There are tools to remove the burrs of Auto Stamping Parts

1. Hole: Deburr the hole of Auto Stamping Parts using a chamfering knife or a drill bit with a large diameter.

2. Side: Use trowel, oil stone, sandpaper, whetstone.

3. Welding slag: There are vibrations in addition to the slag tool to remove the brittle burrs.

4. Outer diameter: Conducting the angle of the lathe during the metal stamping process.

Second, manually remove the burrs on the Auto Stamping Parts

1. Electrochemical deburring: If the equipment is made, the cost is not high, economical, efficient, and use.

2. Heat-treated parts can also be deburred by shot peening and surface stress can be eliminated.

3. Use a wind gun with a variety of shapes to get a good burr effect, high efficiency.

4. Vibration grinding deburring (gear burr), high efficiency, quality can also be.